Here is something that probably happens to a lot of people and not just me:

Example: Coinwarz put somes coins on problem status for x reason for some days or some weeks, or remove a coin temporarily and put it back some weeks or months later. So you react and put those coins "disable" in your list. You told yourself "I will put them back on enabled status later when all is fine". 2 or 3 days later, some other coins get problems too. You disable them too. Now fast forward another week (or month): You remember you disabled some coins some time ago that should be fine now but you don't remember all of them and you end up clicking one by one all your coins in your list to see which one is disabled or not.

It happened to me more times than i can count and my list has grown over the course of time to be close to 150 coins. That takes a long time to click each of them just to verify if it is "disabled".

So here is my suggestion: Would it be possible to put some kind of mark in the list that instantly show which one is "disabled" or not. Something like those disabled become marked in red, or get a red asterisk added or anything that would instantly jump on your eyes in the list to tell you which one is "disabled". I think that would really help to do the management of the coins list.

I have some block erupter cubes i would like to use with multiminer is there a setup guide or anything like that to get me started? (mainly concerned about setting stratum correctly)

Steve

thanks very much for the fast response. One last bit do i need to take any precautions with running multiminer and cgwatcher at the same time?

Steve

Good one - I'll include this in 3.1.

Once there is a tested version of the optimized X11 mining code that doesn't violate GPL licenses I will add it to the supported miners. I am looking into this for 3.1.

As far as I understand it is, I just haven't had time to look into it and test it before choosing to support Yet Another Miner. Each of these requires finding an official download, rehosting it myself, etc.

Personally I'd far rather they just contribute this stuff back upstream to SPH-SGMiner, which is already supported. Is that happening?

perfectly understandable you already do such a huge amount . I was more concerned about using a non open sourced version for my own ethical reasons.

Steve

Just a note for those that do not know BFGMiiner 4.0 went live as well a few hours ago.

I updated the press release article that I was able to do for Nate and Luke Jr.  I hope this helps get the word out for them and their users.

Thanks again Nate for the great job.

I have an interview with Nate that I will publish towards the end of the week.  He is really a very interesting guy and talented programmer.

http://www.cryptocoinsnews.com/news/bfgminer-4-0-officially-released-multiminer-3-0-officially-released-tandem/2014/05/24

hey Nate,

I think I've found some strangeness with new bfgminer. it reports a comport error when run as right click launch and from mm it hangs for ages and sometimes even fails to start https://bt.irlbtc.com/view/626361.msg6962740#msg6962740

mm 3.0.2 and bfgminer 4.0.0

You are able to mine both now with MM 3.0 and higher.