my miner stopped hashing today

ASIC STATS is empty

DCR says

DC2DC DCR inductor flag loop 0 (0xD0) = -1
i2c write 0x71 = 0x2 error2
i2c write 0x72 = 0x0 error2

hey it works again,
I reduced dc2dc to 57 and power to 1170

Anybody know if they will discount the price on total order of 4 SP10 units?

Thanks

Rob

Dogie, is 1250 GH/s reported on BTCGuild (1320 GH/s avg on the miners) @ 25C normal for us 120v users?  One of them is only hovering around 1305 (1215 on BTCGuild).

I'm kinda disappointed at these numbers.  These are expensive units and makes a lot of noise.  Was willing to put up with it if I could get 1.4 TH.  I didn't know they had to limit it.  Should have advertised as 1.3 TH to 1.4 TH.  Can't help but feel a bit cheated/baited.

Ignore btcguild, pool hash rates are always variable. It depends what clock rate you're in, if you haven't looked in detail then you've still got the 120V FCC cap on. You need to remove that to remove the cap of power consumption which will allow your unit to hit the higher clock modes.

The numbers shown in miner are usually 1-3% higher then the pool. That is because of the HW errors and discarded shares.
HW errors more common when miner starts (first 30 minutes) and can be up to 3%, but after a while usually around 1%. Discarded shares usually around 0.5%.
Regards`

I'm not quite sure as it detects your mains voltage and will show it then - I'm 240V so can't see it.

You can remove the cap while on 120V as its just software based. I have no idea what it looks like though.

Oh it would be on the usual web interface, if its not there then its probably been hidden. The problem is the firmware is being developed at a rapid pace so things change and move faster than I can track them.