Yah, because stratum disconnected too. cg just waited for jobs, nothing came

!! I did recieve the payouts of the just found blocks on your pool http://gulden.p2p.0x0a.nl:27100 normally. So it works fine!!

Why wait @144, buy @158   Tomorrow you'll have to pay more, I guess

oke set @ 158

I have setup a block explorer for Guldencoin: http://107.161.145.152:8147/chain/Guldencoin

pfff pay pay pay pleas

Good work! It's fast! and did not nag at me for too much results  

I found it  

Just another note to p2pool miners, it makes absolutely no difference to which node you connect, gulden.p2p or dutchpool.org, that is how p2pool works, all nodes communicate their share information and the total hasrate of ALL nodes determines your payout. You can check this on the statistics pages, the local hashrate tells you the nodes rate and the global hashrate gives you all p2pool nodes combined. Example:
Node 1 has 2 miners with each 1mh/s = 2mh/s
Node 2 has 3 miners with each 2mh/s = 6mh/s
Node 3 has 1 miner with 1mh/s = 1mh/s
Total pool hashrate = 9mh/s
So if the pool finds a block the coins are split accross ALL nodes connected, node 1 will receive 2/9th, node 2 will receive 6/9th and node 3 the remaining 1/9th. The only factor that will influence your potential payout is the time you have been mining, p2pool uses PPLNS for payouts, Pay Per Last N(umber) Shares, so if you just started mining your payout will be smaller, it takes several hours to reach your maximum payout, this system was put into p2pool to prevent poolhoppers from jumping in and out, the good part about this gradual build-up of payout is the fact that if you would decide to stop mining for whatever reason, your work put into the shares is gradually going down, so it is possible that even hours after you stopped there might still be some coins coming in if the pool finds a block. If you want to know more about p2pool please read this page: https://en.bitcoin.it/wiki/P2Pool

Did you get the confirmation mail.