If anyone can find out how to rma a bad board from FC or Canary's GB please post info here, thanks.

I did yesterday as well emailing the customer service address and posting earlier here with no response from anyone as of yet. I have a board that has one bad chain (---) and will only hash 157 out of 205. It's a holiday weekend here so I will give the benefit of the doubt and see if someone responds by Tuesday.

Thanks, appreciate it.

This is a shout out to friedcat how about a gui with a rollover pool .. the ethernet controller has no rollover pool.  antminer s-3 allows 3 pools.  while I sleep if ghash goes down I lose my hash power. Would be nice to have a two pool choice or to at least state your controller does not auto switch pools.

it never lite up?   Try plugging it into a giga byte switch via ethernet jack and use a 5 volt positive center dc plug .

I know you are tech savvy enough to have a laptop with a 192.168.0.1 .


I run everything into a dlink router 192.168.0.1
If you are ping at it with a laptop to controller the laptop needs to be  192.168.0.1

 

I will walk over to mine and check it.

I
 a) power off the miner.
b) power off the ethernet controller--------i am using 5 volt 1 amp wall wart for this
c) pulled the wire that joins the miner to the controller
d) eth only plugged in  I put a 5 volt center pos dc in the eth controller and status lights lite up

So with ethernet cable and a power source those status lights turn on.  and with full connections they also turn on.

  sounds like rma for that gear.

you have one miner correct? if you had two you could chain it to the other controller.  I would say ship it to me and I could run the two but if I recall you have great power prices?

yeah maybe I will buy it .  pm me later on

Who did you get a hold of for the RMA I can't seem to get an answer from anyone??

I messaged PB direct on QQ, and an email. Email is un answered. PB gave me a return address via QQ.