do 55%tdp 120 core 400mem, if you can increase mem even further it will give even better result

I think the Fury is quite good. But the nVidia is catching up fast. The 370 figure is much better than expected.

It's very interesting how the nvidia 1070 can achieve such high scores while the RX 480 is still sucking at ZCASH because:

GTX 1070 Single Precision Processing Power: 5783 (6463) Base/Boost
RX 480 Single Precision Processing Power: 5161 (5834) Base/Boost

Memory perf is the same.

There is a 10% advantage when comparing raw power but in Zcash it's 60%

If your electricity price is cheap, it is better to use the R9 Fury. If it is high, then it is better to use the nVidia.

It is because your GPU has too low voltage during some load spikes.
You can try until it gets stable:
1) increase GPU voltage in 6 mV increments
2) decrease GPU overclock in 10 MHz increments
3) decrease intensity for this card 1 at a time
Or some combination of these

let's talk again when nvidia is fully optimized, there is possibility of another increase, it was said that nvidia has better potential on zcash, this isn't ethereumwhere bandwidth matter...

on the other hand amd is done, very small margin few %

Not only that but they say resale value is an issue.

If I can buy 1.65 R9s for the cost of 1 1070... I can buy more gpus which when I resell will still net me equal money... Because although the gpu won't be as valuable I am able to buy more of them for my money.

Not to mention they ROI faster because they are cheaper.

HI! Thanks a lot for the help!

I just tried that, after reinstalling and patching everything, ( I even tried changing the GPUS mod by lowering TDP from 100 to 90 and I think it was even worse) and that didnt solve the problem, I couldnt even finish the NiceHash benchmark test as it crashed after a couple of minutes.

Also, I am working with intensity 7 already

BTW, I realized it is always the 2nd GPU showed on Afterburner, I swapped every GPU between every PCIE slot, I also tested every card on the 16x port to see if every one of them could send the signal to the screen with no problems so I am guessing it might be MOBOS fault... ( I have every PCIE set to gen 2, 8x 4x 4x, and I also deactivated the audio inboard  on the BIOS)

leave everything as it is !

just lower your memory by 50 the voila ! prolly your starp is too high. it generally happens to elpida rams gpu.

you might wanna add some Mv to core.

try that n see

   You have not specified the right price Fury graphics cards. In the same shop in Germany graphics cards have the following price and price performance is as follows:

                  Card                                                 hash rate      power       cost        $/Hash
R9 Fury (Sapphire Radeon Nitro R9 Fury Tri-X OC+ )   300 H/s        150W      346 Euro     1.153 Euro
1070 (Manli GeForce GTX1070 Ultimate)                   370 H/s        150W      419 Euro     1.13243 Euro
1070 (ZOTAC GeForce GTX1070 Mini)                        370 H/s        150W      443 Euro     1.197   Euro
1070 (Gigabyte GeForce GTX1070 Windforce OC )       370 H/s        150W      459 Euro     1.24  Euro

However, not all nVIDIA 1070 to  hashed 370 Sol s. My EVGA can only  350 Sol/ s and a very overclocked.