Miner doesn't work correctly with dwarf zec pool. Seems it's struggling with dev fee. A lot of reject from time to time and devfee connect fails.

i have a very old HD7790 cards
this piece of sheet gives

works perfectly on miner v9.1, win7x64, for 2 days w/o any troubles....

https://en.wikipedia.org/wiki/Radeon_HD_7000_Series
1000mhz cpu, 1500 mhz memory and only 896 cpu units.
one card takes 40w and another one 60w. so i guess 200-250w per system with 2 this cards.
and you can compare power to rx480 with 1266 mhz cpu, 2250mhz memory and 2304 cpu units.

in all benchmarks (WPA (56/200mh/s), FAH (50/250 PPD) etc) each rx480 gives about 3.5-5pcs of hd7790.
if ETH i can't get the hashrate because my cards is 1 gb, but on the net there are digits like 5-6mh/sec, so its 31/6=5.1 times...
and only in ZEC each rx480 gives 200/85=2.3 pcs of hd7790.
so, this digit looks very sad, like theoretical 2304/896=2.57 pcs....
i don't know why hd7790 works so good to compare to rx480, may be a very good core code for hd7790, or may be a very bad code for rx480, or may be i'm totally wrong in all

I noticed the same but it didnt affect me. I'm still getting 20% more in dwar than flypool. I will switch if the profit drops.

Double check, I had the same 300MHz problem when I first set up my rigs, it turns out I had to have a monitor plugged in to the primary slot - for me that was the 2nd PCI e slot from the top (not the first 1x slot).

You get a new job when a block has been found. Yesterday it took 19 minutes between 2 blocks. The solution is for claymore to remove this check

Why don't read few lines below "* Hashrate below threshold FAQ"?

It's not working.  The only way I can get back to 90H/s is to get the GPU out, reinstall the driver.. Any other solution to this and what is the possible cause?

V9.1 with my HD7990's i get 201H/S per chip (400-405 in total, MSI brand), really good increase!

It depends on price and duration, why not?

Hey guys, just wondering what your hashrates were for a 1070? I hear they hash at about 100 watts, but I can't seem to get a solid figure on hashrate.

With my RX 480's (on Clay's 9.1 miner), I'm doing about 230 sol/s at 1333/2100 with a decent under-volt.

So I'm thinking of building a new rig, and so I'm wondering if I should go with maybe 2 1070's. My power is already cheap, but at current zcash price, it takes me about 4 months to ROI on an RX 480. So would 1070's ROI faster?

What is your guys' hashrates with a 1070 on Claymore 9.1, and approx what is your power consumption? Thanks so much!