I'm using Cudaminer for the 6x 750Ti running on an ASRock h81 pro-btc motherboard, and using windows 7.
I can't get the last card on my 16x pci-e slot to work while the other 5 works, and I'm only getting 450 khs for 5 cards. Am I missing smth??
Help!
Based on my experience with prior cases, I'd say the low 450 kH/s is probably caused by running cudaminer with the -H 1 switch. Try -H 2 (which is the default by the way).
No idea about the 6th card. Change the type of riser? If using a riser on the 16x slot, make sure the VGAPRESENCE pin is shorted?
Christian
Thanks Christian.
Already using -H 2. These are my settings:
cudaminer.exe --algo=scrypt:2048 -o stratum+tcp://east1.us.stratum.dedicatedpool.com:3367 -u yourworker.1 -p password -i 0 -l T10x20 -C 1 -H 2
What is VGAPRESENCE pin? And how do I do that? What's it for?
Does the 16x slot work with less than six cards installed?
Does the riser or #6 card work in any other 1x slot?
Is the 16x slot set to Gen1, Gen2, or Gen3?
Is the motherboard ram set to the correct timing?
Newer USB risers have the sensing pin short built into the circuit board, so you shouldn't have to a run shorting wires if you are using those.
all 6 cards work, only card on the 16x slot.
I am not sure if its gen 1/2/3 , how can i check?
mother board ram timing --> how do i check change ? and what are the right settings?
with this many cards realistically we need to know the following;
What cpu are you running?
How much memory?
What PCI-E versions are the cards running on? (1.1 2.0 3.0)
What type of risers do you have? (Ribbon, Ribbon Powered, USB Powered)
This wasn't addressed to me but is relevant anyway.
4GB Ram
Risers are ribbon non-powered, all 1-16x risers.
UPDATE: When plug in 6 cards, i only detects 5 --> all 6 card fans r running.
Tried plugging only 3, but hashrates remained at 10, 13 and 45 for each of the 3 cards.