Overclocked 750Ti now have ~1.20 Kh 

My i7 3610 laptop CPU is around 400 H/sec - half of what it was at NF=14.  That's no surprise whatsoever.  My 2GB R7 250 cards lost quite a bit though and are only twice that of the CPU, but are still using less wattage.

U on R7 240 4GB cards is about 1.1, down from around 2.7 (i think)
R7 250 2GB cards are stinking up the place... U of < 0.7

Don't forget to vote in the 10,000 YAC Meme Contest...

http://forum.yacoin.org/index.php?topic=661

(Edited) here is the thread with all of the memes submitted:
http://forum.yacoin.org/index.php?topic=631

I can almost see botnets on the horizon.


Now 11 hours later the block time is 3min and there are 616 blocks to go. There will be 30 hours before the difficulty drop (to 0.005). Difficulty has (hopefully temporarily ) reached escape velocity.. this has better not become the beginning of vicious difficulty cycles:  difficulty drops to the floor when retargetting -> miners dive in and mine like there is no tomorrow -> difficulty goes through the roof and retarget-> miners leave and mining almost stops  -> slow confirmation time -> difficulty drops to floor -> long wait -> repeat

Yeah, I think most mining pools use the litecoin difficulty adjustment calculations (because it is already built into the pool 'template').  I find myself looking at it quite often, but then I have to remind myself YAC adjusts each block.  It would be nice to see the actually next block estimated difficulty in pools though...

How come the block time is almost 3 min for so long ? It should go back to ~1min soon after the N change, right?

You know I added cryptoaltex to the OP weeks ago?  Even then, at least in my opinion, there's really not enough volume or orders on the orderbook there to really justify being listed..

YAC has a maximum difficulty adjustment of 1% per block.  So it takes a little while for the difficulty to even out.

In previous N-factor increases, it usually took 1-3 days for the difficulty to stabilize.

ahhh, i see what you're looking at.  I do see that on the pool, and it may actually be fairly accurate as to WHAT the diff will wind up as, but it's going to lower by a fraction every block.  I usually just look at one of my miners to see what it is... we've gone from a reported 1.08k diff to 1.02k in less than a day.  Would I like it to adjust faster, probably, but it's also not going  to skyrocket from really high hashrate for short periods of time either.