I have 'x's appear an disappear on all of my Ant's but only once I have need to reboot one that went a bit sick after 3 days. I have one at present with 64 'x's but the pool says it is running at 190GH/s with accepted share figures no different from the other ants I have. I suspect I will look at it tomorrow and it will show 64 'o's instead.

Am I correct thinking I don't need to run a damn Stratum proxy with these?

Yes.  It's running cgminer underneath the web interface, which supports stratum.

So I'm looking at getting 2 of these, each with 2 blades. I'm debating about getting 2 CX600M PSUs (each has 2x6-pin PCIe). Alternatively, I'm looking for a single PSU that could power both. But I'm not sure of the wattage required. Dogie says to expect about 500w each, so I'd need more than 1,000w and 4xPCIe, right?

I was told someone was successfully running each miner on only 430w, and that 750-850 can run 2. Does that sound about right? If so, it dramatically decreases the cost of the power supply to run 2 of them!

Also, does each blade have an ethernet port, or the chassis itself?

I had a corsair CX600M running an antminer at 200GH just fine. I snipped the 8-pin ATX MOBO cable and ran 2*12V and 2*GND to each blade without issues. With the new antminer with PCI-e connections you shouldnt have any problems

Each chassis needs an ethernet port

Are you serious? I just bought 6 AntMiner S1's today, so that means I will be needing 12 Ethernet cables to run these? That has got to be a joke, right?


I wish KnCMiner was selling more Jupiter units. They have the best miners ever!

Thanks for the answer... the response from the guy above made it seem like each blade needed an Ethernet port, not each unit. Again, thanks for the clarification.


Is there an easy step by step instruction for overclocking these units to above 200Gh/s? And when I say easy, I mean each step is clearly explained, rather then just saying "SSH into the miner and change the config file..."  I am not all too familiar with SSH. Right now I have PuTTY and winscp525, but I don't know any commands or anything so I don't know how to edit files or navigate in it. Any help will be appreciated.

Also, I have a Corsair HX850, do you think that will be good to run two units at 200Gh/s? If so, I will buy two more to cover the other 4 units.

Again, thank you in advance.

Connect putty to the address, via port 22

Once you login do the following commands

vietc/config/asic-freq
Press the letter i to get a prompt
Change the required stuff.
Then hit escape and ctrl zz. (This will save the file and exit)
Restart.

If you still can't get it setup team viewer and ill login and you can watch me change if for you.

Remove the "#"s from the 400M set of options and put "#"s in front of the 350M options.  Without quotes of course. Then save and reboot.