<<  >> (p.655)
    Author Topic: Swedish ASIC miner company kncminer.com  (Read 3050099 times)
    arlekyn13
    Sr. Member
    ****
    Offline Offline

    Activity: 288
    Merit: 250


    View Profile
    October 02, 2013, 03:12:45 PM
     #13081

    I could really use some help with my PSU setup. I got 2 X Enermax Maxrevo 1500W to power 1 Jupiter and 2 Saturns. Here is the distribution of the virtual rails:



    I plan on connecting my Jupiter with 4 cables (each cable has 2 X 6+2 PCIE connectors, but going to use just one connector for each cable) using 12v3 (upper left), 12v4 (upper middle), 12v5 (lower middle) and 12v6 (upper right).
    Is this correct? I have no experience working with PSU's...

    I've also found this piece of info which doesn't make much sense to me:
    "The 12V1 rail should ideally power at least half of the peripheral/SATA sockets and not only the 24pin ATX connector. The 12V2, which feeds the first EPS connector, could also feed the other peripheral/SATA sockets. You should, in case you need the second EPS/ATX12V connector, connect its cable either to the middle top socket or to the top right socket that are fed by the 12V4 and 12V6 respectively. These rails provide power to a single 12pin socket and to the peripheral sockets, so don't mix any PCIe connectors with this EPS, something that could lead to OCP activation."

    Also, since I plan on upgrading the 2 Saturns to Jupiters, the 2 PSU's should provide enough power for 3 Jupiters. But how would I connect them?

    1CmrswU7JYpi9WNC8EHWCV3aam1FJsW2Zu - to show appreciation for my work
Page 654
Viewing Page: 655