a) Get an Ohmmeter or DMM

b) Get an HB or softer Pencil

c) Locate R02F resistor. Donot mod R01F.

d) Make sure R02F measures 1.3KOhm

e) Rub pencil on the surface of R02F 3 - 4 times

f) Measure resistance, if it's 1.2K plug the board in

g) Measure output voltage, and repeat steps e,f if necessary for fine-tuning

h) Hash like a boss

we need a pictured guide for dummies ... so we can break our boards trying ...

Any word on the error rate, I managed to get to 30-33Ghs for short periods and huge error rates, with 0 (zero) actual gains.

or leave an ssh window open and  run this:

while (true) do tail -3run/shm/.stat.log; sleep 305; done


( not run/smh )

Anybody knows what "speed->0" at the end of the .stat.log line actually mean?

2       AIfDSo  55      0.243   2.019   17      126     0       0       191     [0:1]   726     0 1 2 2 1 0 0 0 2 0 3 0 4 1 1 0         9 8 7 7 8 9 9 9 7 9 6 8 5 8 8 9    speed->0

10      AIfDSo  55      0.272   1.924   19      110     0       0       182     [0:9]   722     0 2 1 2 2 2 0 2 0 1 1 1 2 1 1 1         8 6 7 6 6 6 8 7 8 7 7 7 6 7 7 7    speed->0

#2 and #10 chips are not doing what they suppose to.  I'm not sure if it is assembly or my configuration.

EDIT:

After a while the rates drop completely:

2       AiFDso  55      0.014   0.550   1       35      0       0       52      [0:1]   723     0 0 0 0 0 0 0 0 0 0 1 0 0 0 0 0         2 2 2 2 3 3 3 3 2 2 1 2 2 2 2 2
10      AiFDso  55      0.072   0.528   5       34      0       0       50      [0:9]   715     1 1 0 0 0 1 0 1 0 1 0 0 0 0 0 0         2 2 3 2 2 1 2 1 2 1 2 2 3 3 3 3