mines at 28 days but still shows online. but it is a good idea to check regularly.

After a power outage this past Monday, the miner on my Apollo will no longer start. The node starts just fine, but the miner is offline and fails to start... with no error messages displayed when I attempt to start it. I've tried fully shutting down the Apollo, disconnecting the power, and powering it back on - but the miner never starts (only the node starts).

My Apollo (and the official PSU) is on a pretty hefty surge protector, so I don't think it sustained electrical damaged. (Plus, it seems unlikely that electrical damage would leave the Apollo partially functional like this).

My guess is that the issue was caused by it failing to shutdown properly during the outage (during which time the power flickered on and off several times).

Any ideas? Do I need to reimage the SD card and start over?

I'm running Apollo Web v0.1.0 beta.

Yea if the power went in an out multiple times the SD card probably got corrupted. A re-image should fix it.

Ive had my batch 1 since day 1 and has always been a sturdy little machine with relatively few glitches. Since upgrading the MCU to enable node support ive had problems.
I have a feeling its because the MCU runs hot and causes problems i.e network disconnects and then the machine fails. It seems to happen when the MCU hits 45 degrees at about 1hour even in ECO.

Tried with out node and still no luck, downgraded to image 1.29 and still the same. Finally replaced the original MCU and every things fine again obviously with out node support though.

So now running back on 1.29 image with original batch 1 MCU and its running sweet even in turbo mode the MCU bearly reaches 27 degrees. Compared to the Masternode version which runs upto 45 degrees and then glitches the machine.

Is this something software could fix i.e change the parameters to let the MCU run hotter if thats what is does, or make it run cooler.

Thanks sticking to no maternode batch 1 setup until further advice.

Don't forget this, please. Not sure if easy to add this feature. I have kwh price about 0,10 € with sunlight. About 0.05 € by night. You know  .

I emphasize that this option is very important.

Hummm, interesting, so my full node is not validating transactions from everyone else even when connected to the publicj network? If I do not make transactions on my own then what is the point? how is that we are helping the network?

Can anyone help with this. 

I have forwarded port 80 but get stuck on the setup page, even though the Apollo is working (for months)

CHECK YOUR ANTIVIRUS--

Your AV software may be blocking the graphics update pushed from the Apollo.       --scryptr