I haven't been on here in a while, and I'll read back too see if I can find info. I ordered one of the new power supplies for the Apollo a few months ago and haven't heard anything from Futurebit. Are they still coming?

There is a post three spots above yours that explains that not only is this the wrong place to ask that question, but also has an explanation of shipping timeframes.

Hey everybody!

(just imagine that in Dr. Nick's voice, ha, now it's stuck there)

Just curious if anyone had experimented with auxiliary fans or ducting to move air out and away from your Apollo's.
I have a couple L3's that I've finally perfected some duct work with an exhaust fan and was thinking about trying to tie in the Apollo as well.
Be glad to hear thoughts, concerns, and suggestions on the build idea.
That being;
Removing the cover, side plates, and stock fan.
Putting a 120mm on the heat sink and attaching it...somehow.
Zip-ties are great.
Running that off a 12v power supply that is running my exhaust fans, which are also 120mm, and has an adjustable output to control the speed.
Attaching a 4" shroud to duct into the existing work.
One of my major concerns is that because the 120mm fan is a bit larger than the heat-sink, it will not pull enough air "through" the actual heat-sink because of its super sweet design and just pull air from the sides.
A possible fix for this would be mounting an fan with a shroud on both sides of the fan to restrict the air flow to the actual cutout of the existing fan exhaust on the cover plate.
jstefanop, is there a fan sensor safety like the L3 have or just the temp sensors?
Just to be clear, I have zero problem with the noise levels, its minimal anyway, or actual heat coming off of the Apollo.  This is just messing around.  I live in Austin so always tinkering with ideas during the summer time.
The next project will be taking on littleless's solar power setup.
Thanks y'all,
Happy Mining.

Hello guys! As with a lot of people here I'm brand new to mining. In fact, the ease of the Apollos is what got me hooked. My question is more pool-related and not hardware related. I am pointed to nicehash as a primary and litecoinpool and a secondary. I find that my equipment fails over to litecoinpool just about daily. Is that normal?  Is that something on the pool side, or should I look at my hardware?

Thankyou for asking this question and answering.
Could not understand why I could not run a multi strategy or mine two different coin, like lite coin and block chain note NTBC
it seems it is one or the other

It can be run directly on the apollo, I actually thought about doing this for a temporary fix until I have time to fix bfgminer.

Yes this is normal. The number of hardware errors does not really matter, just keep an eye on the HW % on the top box.  Even the best units won’t have anything less than .5% errors. As long as it’s under 2% your fine.

Is there a way to reset dashboard password on the box or I need to re=flash the image again on SD card?  For some reason my password is not correct even thou i was able to access it before.

Unfortunately no, this is by design. You need to re-image the sd-card if you forget you password.

Thats weird, you could try lifting the controller board a bit out of its socket and re-set it in there and make sure its seated in there well.

If its still not working just shoot me a PM, could just be a bad LED module that need to be replaced.