I have been playing around with a variety of different numbers also  best overall performance (load, HWE, Discards, and stales) I have gotten is setting all 3 settings to 1 and that is what I am staying with.

Waiting.  They could at least tell us WHEN to expect it.  How hard could it be to process these?  It's a drop in the bucket compared to what they have collected just from users here alone.

You check the pool address is correct along with the worker/password. If that doesn't help go reboot route.

Yes

I'll be under-clocking and under-volting my S1 in a month or so as it will make it more efficient and thus, profitable for a little longer.

Thanks for posting.  I'll be playing around a bit today as well.

Are you using 2 or 4 cables? I would like to try to go to 225 after I get some heat sinks for the DC/DCs but I will only have 2 cables available.

RMA for a faulty temp sensor is going to cost you more then its worth...

If your concerned one of the fans is running to slow because of the sensor reporting 0 just cut the blue wire (yes, cut the blue wire) on the fan and it will run full speed.

I am glad "CK" provided his input as I too removed scan and expiry from the settings for pool operation but have put them back in for P2P testing as "CK" said was worth testing. BTW apparently "BestShare" is always reported from P2P but not all major pools. Don't know if you noticed that or not so I figured I would throw that out there.

what does it look like?

is part of the module un plug the fan and place in the other one ie reverse it and see if the temperature shows on the other controller instead. if this does not work then it  will be controller and am not sure where the actual temp sensor is no doubt some tiny thing sitting under the heat sync somewhere but cant actually see. Avalon had a wire sensor you can replace and I did exactly that on my avalon.

Antminer on the other hand think its part of the unit built into it. only option try flipping the fan to the other end and flip around see if that sensor works on that one if it don't then it. However having said that this is the S3 I would need to see it in parts to see where the sensor is on it maybe someone already had one in bits and broke down. if looking at one inside with the tiny heat plates then could be under one of them or its built in.

If built in on a tiny resistor sort of thing then you only have 2 options 1 is flashing firmware seeing if that will work or 2 living with it and contacting bitmain about it for poss RMA or some sort of guidance on where location of it is and seeing if damaged.