did a quick search, didn't find much relevant to this:
Suddenly when I run ccminer 2.0 for lbry or lyra2rev2 both of my rigs exhibit a behavior where they will instantly power down. Its not power related, they are on separate circuits, have been running zcash mining 24/7 for several weeks.
Intermittently, usually within 5 seconds to a few minutes there will be instant power off. Using CUDA and gtx 1080's and gtx 1080tis in separate rigs.
There's nothing in event viewer after the fact, and the shutdown is not a blue screen - instant power cut (and subsequently reboots due to BIOS reboot on power loss).
Has anyone else experienced this before? Its crazy, and only ccminer does this. I've tried 1.85 as well, different nvidia driver versions (382.53 newest atm). Super weird.
NOTE: It really isn't power related - I'm nowhere near limits of current temperature. One of the crashes did take longer than usual, and I was able to get a windows 10 kernel MEMORY.DMP. I'm almost certain its an nvidia driver fault.
It is power. If it's instant, they don't get time to warmup, so it's not heat. If it's the OS it will BSOD or do something more graceful. Your powersupply is more then likely too small or trips too early on overvoltage protection (which is why you have to overprovision).
Zcash uses less power then Lyra2v2, especially if you turn down the TDP.
well I appreciate the responses!
Both are Windows 10 Pro Creators Update x64.
Rig 1:
2x Strix 1080ti, Corsair AX1200i 1200w plat PSU. total power load is 520w, its not coming anywhere near its limit. Cards undervolted to 0.812v, pull about 215w each with zcash and 202w with lbry. both in mobo. I definitely don't doubt the overvoltage protection trip, its a known thing with a lot of AX1200i's. However, I've pulled far more wattage through with both set at 120% power limit during stress testing, with each consuming 320w simultaneously.
Rig 2:
6x Gigabyte 1080, undervolted to 0.825v, ~135w each. single 8pin, powered risers. no issue running zcash for weeks. Seasonic SSR-1200PD 1200w plat. Total load is ~930w from wall, however kitguru has tests pulling 1350 sustained from it before a shutdown.
The fact that this is happening on two separate circuits with different powersupplies, different cards, different configs (direct in slot on mobo, other rig is on powered risers) lead me to believe its really not a power issue - though I understand why it would be top of the list. Hmm.
The only common things I can think of are the same OS, same nvidia driver version, and CUDA 7.5 8.0 from different ccminer builds. I also wonder if the ccminer implementation of the lbry lyra2rev2 algos contains some power spiking, which might trip over voltage protection on the PSUs.
