Discovered now your page. If I ma suggest: Put a rough estimate on mined coins per day and resulting $ earned. This will make it stand out.

it's not dead unless you get - - - - - instead of o o o o or x x x x
did you plugged in everything correctly?

open it up and see if you can figure out what the issue is. could be a bad chip, burned, bad solder etc.

The payouts are linked to when the blocks are found, so seem to come through randomly. You can get a payout twice in a minute and then not for a few hours. So, yes, just be patient and leave it running for a few days before you compare. I have personally found it the most stable type of pool, having tried prohashing, zpool, granatgas and suprnova. I also like the regular micro payments.

I love this regular micro payment ... which pool are you using?

I have a big problem with FedEx France, they lost 3 shipments of PSU's, and they admitted that the shipments had been lost
They asked me to contact FedEx China 
how stupid ??
What should I do? Can I sue them?

From my limited knowledge and experience i would say your values are normal.  Your temps are high though, i try to keep mine sub 80*C.  Any higher and you can risk damaging your machines or fire.

Has anyone here had any luck correcting the HardWare (HW) issues with their D3's?  I have 2 that are running with over 50,000 HW in a 24 hour period. I have tried letting them cool down, a complete factory reset/reboot, updating firmware, etc... The temps are good, with the highest being 74*C right now.  Output is good, power is good,

Two of my other D3's run with less than 100 HW in the same period. 

Any suggestions are greatly appreciated.

I just turned my problem children down to 525, It looks better so far.  I'll play with is and see how it goes.  Thanks for the recommendation. 

Any idea how HW issues impact mining?

didn't found info while googling around so I'll ask here if anyone is willing to help and/or experienced something like this.

couple days ago I managed to build a little farm with ~45 D3s, so far all of them are working nicely except of one,
hashrate drops to 0 after around 10 minutes of working, after rebooting it starts mining on 19Gh/s and then bam and 0. I did try remote steps like resseting, reconfiguring, lowering frequency, etc. but still same.
With my experience in bitmain product in this case I have two options, play with firmware or change the control board itself.
can anyone give any advice?
cheers