Any ideas on how to break 1300H/s?

Right now it is set to 85C in OverdriveNT.  Set to 70C ?

if you want to restart miner x time due hash drop here is simple script .
my miner restart every 30 min
Ps don't close script terminal.
creat bat file and put this.
Edit set commandline and set u config

Thank you for this script!

This makes a lot of difference, because it improve the whole reliability of the system.
Normally I have the software crashing after few hours of working just smoothly as it could do, yet all in a sudden it just stops.
On this way, as it just restart before entering the "crashing zone", it keeps working endlessly.
Moreover I can push performance higher, since it restart after 30 minutes and it does not approach the "crashing zone".
It helps that Cast miner restart it self and get back going full speed in just a few seconds, contrary of STAK, which takes quite some time to restart.
Now I have 4 Vegas and 1 RX580 all together giving 9000 Hs, at the pool.

Sincerely, thank you a lot.

4gb ram. 1 vega 56 with 4 rx480s. Followed new guide for the vega. Uninstalled wattman. Using august blockchain drivers. Overdrivent tool. Soft registry settings. 60gb page file. Enable and disable the card on reboots. Run cast-xmr as admin. Everything is stable but the vega starts at 1900 and works its way down to 1300 and stays there. Im testing with just the vega for now. Using claymore the 480s work fine.
Any ideas on how to break 1300H/s?

Getting ~900h/s with my rx 570 4GB's
overclocked to 1360/2000. bios modded. not sure about power consumption.

anyone getting better/similar results with the same card or should I be concerned with my cards melting?

3 error it's nothing..

Probl is network issues. Miner  don't send share etc..

hey :
https://imgur.com/a/ttkIf    3 Errors Why ? any ideas ?

https://i.imgur.com/7BTGTAp.png

Press "S" for stats... Will give you "the idea" why you have errors...

hi Guys im running cast xmr successfully with 2 vega 64 LC and 2 RX580 Nitro+ 8GB

Vegas 2040h/s each
RX580s 780 and 890h/s

no registry mods just using wattman with HBCC on. this seems to go against all advice, am i reading too much into this

i still need to see what power i am drawing but my vega temps are around 32c and havent risen all day.

is this ok?