Where do u rent it out at? How reliable are the renters, as in how many actually set vardiff correctly and dont cause the titan to freak out? Im curious, seems like renting is moot now =/

You have to use win32diskimgr or w/e it is....
Given ur issues downloading it Im willing to bet its corrupted somehow.

My firmware is not an upgrade firmware its a clean flash. You have to overwrite ur SD card.

Out of interest does anyone else have a die that only half works like this....



What happens is when bfgminer starts, it says the die is configured successfully, 0 shows around 4 amps and 1 shows around 42 amps.  There are no error messages regarding this die but after about 5 minutes it reports that it is configured successfully again, and the amps go to what is in the screenshot.

It's been like this since I got it, have tried voltage and speed tweaks so don't think there is any hope for it, was just curious.

Guys the stability of the titans can be improved so that they dont break down or overheat all the time. Im working on ways to repair them and make them stronger so they dont break down as much. Hang in there, there is a lot of trial and error I need to do. This will include larger , faster fans, enhanced cooling on the vrms, and thicker gauge 3 to 1 pci-e connectors. When Ive got everything working perfect , I will offer my services to the public. Ive got atleast 13 dead titan cubes, so I have plenty to practice on

Vegas

Sadly the only limitation is not within the cables themselves. Its within the PCIE 6pin connector as well, its actually rated up to like a max of 23A current. We run these things really close to that limit ..... 24/7

yeah when messing about with my die(s) (1 die dead in two cubes) I get that once in awhile...never can get them both back thus why the 2 dies on 2 cubes
are set to OFF

as I've said before if I power down my unit say 7 times to tweak like I did to set a couple dies down from 325 to 300 on adv page due to heat (summer) and
got a cube 10c on the adv page die temps down as a result

with the constant power downs in those 7 power downs and up etc..... 2x I had dies on OTHER cubes come up as dead so again re-power and the 6th time
before reboot I lost a whole cube....so when all worked the 7th time my ambition for further tweaking to play with the previous back in the day dies that were
set to OFF was less then enthusiastic to say the least

would be nice to get a 'former' tech from knc on here see what they do/did to get stuff back up ..but I suppose he (thou no longer employed) signed a NDA.



it is the only way you can do the FULL img to a NEW SD card (i use Sandisk 8gb class 10 SD's)

only way I play with stuff new SD just follow the instructions should still be on the www.kncminer.com page

and of course the instructions for the tweak on here for the new stuff you hopefully have downloaded

That was something we were considering , but after looking everything over, its a really bad idea. Im sure Tarkin will remove that option in the next release.

@GenTarkin. The biggest threat to these miners is the temp of the VRM. I think the critical temp of the vrm is around 85C. Can you put a switch in that will shut down the die @85C , that we can choose to have this active or not, or even better have a drop down to choose the shutoff temp, and a switch to activate or not.  I can send more btc if you can do this. This prevents permanent damage to the VRM, thats what overheats, NOT the processors or dies.

Vegas

this is a dumb question..i know zip about such things..but can you put some kinda heatsink (assuming you can find some that fit) on the vrms...or is that just silly? (likely)